Die board laser cutting machine Common troubleshooting

                                       Die board laser cutting machine

1, fault phenomenon: boot is not powered

Fault reason: external power supply, poor contact of the machine air switch emergency stop switch

Treatment method: use electric pen or multimeter to measure external power supply, machine air switch, lock switch, emergency stop switch is energized

2, failure phenomenon: boot trip

The cause of the failure: (1) Check if the electronic original is damaged; (2) Whether the line is burnt out or loose;

Treatment method: (1) replace the electronic original; (2) check whether the line is complete;

3, failure phenomenon: the cutting board does not blow

Cause of failure: Is the blown electronic valve damaged?

Treatment method; replacement of electronic valve

4. Fault phenomenon: the cutting seam becomes larger or not worn.

The cause of the failure: (1) The focus is not adjusted, the focusing mirror is watery or oily; (2) The laser tube is weak, and the focusing mirror is damaged;

Treatment methods: (1) reduce the focal length, clean the lens; (2) replace the new laser tube or reduce the cutting speed, replace the lens;

5, the phenomenon of failure: boot does not light

The cause of the failure: (1) The water tank is not energized or there is no water in the water tank; (2) Whether the water tank signal line is loose or damaged;

Treatment method: (1) Check if the water tank has water and work normally; (2) Check if the water level gauge is at the normal water level;

Master the above methods, which can be easily solved when the laser die-forming equipment fails, or quickly cooperate with the maintenance personnel to solve the problem.

For more information please contact the Worthy Tall staff.